Cove Skimmer / Cove-I 250DC

Product no.: 118624

Manufacturer Specifications for cove skimmer I 250

The cove I 250 is the skimmer when it comes to smooth and silent running.

• The cove I 250 is a skimmer for operation inside the filter basin.
• We recommend the skimmer for seawater aquariums from 1000 to 1400 liters.
• The ideal water level should be between 18 cm and 26 cm.

Technical specifications.

• - Measures of the skimmer width 282 mm, length 375, height 600 mm
• - toolless disassembly
• - Very rapid dismantling of the reactor tube by bayonet fitting is possible

An additional 38 mm for the removal of the foam pot, to the height of the skimmer for installation in the subterranean basin must be planned.

Technical data of the pump:

UP 8000 skimmer V24 Pump

• - Dimensions of the pump (with pipe connections): Length: 186mm Height; 152mm width: 100mm
• - electronic regulation in 5 watt steps 5 - 50 watt adjustable
• - 24 Volt protective small voltage
• - 10 Volt interface
• - 32mm pipe connections
• - Pump is disconnectable from controller
• - 24 Volt power supply included
• - Power cable 1.80m Control cable 3m
• - Dry-running protection function
• - Switches back to the previously set value after power failure
• - Power supply MEANWELL power supply 100-240V 50 / 60Hz

Delivery:

• 1 x cove I 250 skimmer
• 1 x UP 8000 skimmer V24 pump
• 1 x spare parts set
• 1 x Operating instructions for disperser pump
• 1 x Instruction manual skimmer

Pump: UP 8000 skimmer V24 :

• The UP 8000 V24 skimmer is a new skimmer pump, which was developed for highest requirements in seawater aquaristics.
• The new 24 volt brushless DC motor enables absolutely quiet operation and offers a maximum of safety due to the safety extra-low voltage.
• The maximum output is 2000 l/air per hour (with cove air intake nozzle), with only 50 watts of power consumption.
• The controller allows an adjustment of the air output from 5 to 50 watts in 5 watt steps.
• The needle wheel and the venturi nozzle are also designed to run absolutely effectively and quietly to meet the highest demands.
• The pump can be removed without tools by means of the retaining ring on the impeller housing.
• The shaft and bushings are made of the hardest durable ceramic.
• The aging-resistant and vibration-damping silicone bushings, in which the plain bearing bushes are enclosed, ensure very quiet running.
• The needle wheel is made of POM. The plastic POM has a much higher strength than other plastics. This makes the needle wheel extremely resistant.

WEEE-Reg.-Nr.DE 83382024